Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / ABS with EBD system / Open/Short circuit in abs solenoid relay
circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage)
- Disconnect the skid control ecu connector.
- measure the voltage between terminals +bs (2) and gnd
(1, 23) of skid control ecu harness side connector.
Voltage: 10 – 14 v
2 Reconfirm dtc
- Check the dtc .
Ok : normal code
3 Inspect contact condition
- Inspect the condition of the each connector from engine room r/b to skid control ecu.
Check and replace brake actuator assy
Other materials:
Description
1. Radio wave band
The radio wave bands used in radio broadcasting are as follows:
Lf: low frequency
mf: medium frequency
hf: high frequency
vhf: very high frequency
2. Service area
There are great differences in the size of the service area
for am and fm broadcasting. Sometimes ...
Out side moulding
Replacement
Hint:
use the same procedures for the rh side and lh side.
1. Remove outside moulding
Put protective tape around the moulding.
insert a piano wire between the vehicle body and moulding.
tie objects that can serve as handles (for example, wooden
blocks) to all ...
Light control switch circuit
Wiring diagram
Inspection procedure
1 Check headlamp dimmer switch assy (light control switch)
2 Check wire harness (tvip ecu light control switch)
Disconnect the tvip ecu and light control switch connectors.
check the continuity between the terminals of the tvip
e ...