Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Mil circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
Hint
: troubleshoot each trouble symptom in accordance with the chart below.
1 Clear dtc
- Connect the hand–held tester or the obd ii scan tool to the dlc 3.
- turn the ignition switch on and push the hand–held tester or the obd ii scan tool main switch on.
- read the dtc .
- clear the dtc .
- check that mil is not illuminated.
Standard: mil is not illuminated
2 Check harness and connector(check for short in wire harness)
- Disconnect the e6 ecm connector.
- turn the ignition switch on.
- check that mil is not illuminated.
Standard: mil is not illuminated
- reconnect the ecm connector.
Check and repair harness and connector (combination meter – ecm)
3 Check that mil is illuminated
- Check that mil is illuminated when turning the ignition switch on.
Standard: mil is illuminated
4 Inspect combination meter assy (mil circuit)
- See the combination meter troubleshooting on page
Check and repair harness and connector (combination meter – ecm)
Other materials:
Inspection
1. Fuel injector assy
Inspect injector resistance.
Using an ohmmeter,measure the resistance between
the terminals.
Resistance: 13.4 – 14.2 Ω at 20 c (68 f)
Inspect injector inspection
Caution:
keep injector clear of sparks during the test.
Purch ...
Inspection procedure
1 Prepare for inspection
Disconnect the negative (–) terminal cable from the battery, and wait at
least for 90 seconds.
remove the horn button assy .
disconnect the connector of the instrument panel passenger airbag assy
.
disconnect the connector of the front sea ...
Receiving a call
When a call is received, the following screen is displayed together with a
sound.
To answer the phone
Press the switch on the steering
wheel or select .
To refuse a call
Press the switch on the steering
wheel or select .
To adjust the incoming call volume
Turn the “PWR/VOL” knob. ...