Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Ecm power source circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Inspect ecm(+b voltage)
- Turn the ignition switch on.
- measure the voltage between the terminals of the e4 and e6 ecm connectors.
Standard:
2 Check harness and connector(ecm – body ground)
- Disconnect the e4 ecm connector.
- check the resistance between the wire harness side connectors.
Standard (check for open):
- Reconnect the ecm connector
3 Inspect ignition or starter switch assy
- Disconnect the i10 ignition switch connector.
- check for continuity between the connector terminals shown in the chart below.
- Reconnect the ignition switch connector.
4 Check fuse(efi fuse)
- Remove the efi fuse from the engine room r/b.
- check for continuity in the efi fuse.
Standard: continuity
- reinstall the efi fuse.
5 Inspect efi relay
- Remove the efi relay from the engine room r/b.
- check for continuity in the circuit efi relay.
Standard:
- Reinstall the efi fuse.
6 Check harness and connector(efi relay – ecm, efi relay – body ground)
- Check the harness and connector between the efi relay and ecm.
- Remove the efi relay from the engine room r/b.
- Disconnect the e6 ecm connector.
- Check the resistance between the wire harness side connectors.
Standard (check for open):
Standard (check for short):
- Reconnect the ecm connector.
- Reinstall the efi relay.
- check the harness and connector between the efi relay and body ground.
- Remove the efi relay from the engine room r/b.
- Check the resistance between the wire harness side connector and body ground.
Standard (check for open):
- Reinstall the efi relay.
Check and repair harness and connector (terminal +b of ecm – battery positive terminal)
Other materials:
Replacement
1. Remove console box sub–assy rear
2. Remove parking brake lever sub–assy
Disconnect the parking brake switch connector from the
parking brake switch.
remove the lock nut and adjusting nut from the parking
brake cable assy no.1.
Remove the 2 bolts.
Usin ...
Replacement
Hint: components:
1. Remove rear wheel
2. Remove rear brake drum sub–assy
3. Disconnect skid control sensor wire (w/ abs)
4. Remove rear axle hub & bearing assy lh
Remove the 4 bolts and hub & bearing assy lh.
5. Install rear axle hub & bearing assy lh
Install t ...
Although system is powered,cd cannot be played
Wiring diagram
Inspection procedure
1 Check if a proper cd is inserted
Check that a proper cd is inserted.
Make sure that the cd is a normal audio cd, and that there is no
deformation, flaw, stain, burr
and other defects on the cd.
Standard: normal audio cd.
Reference:
...