Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Ignition coil primary/secondary
circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
Hint
: read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the air–fuel ratio was lean or rich, etc. At the time of the malfunction.
1 Perform simulation test
- Clear the dtc
- shuffle arrangement of the ignition coil and igniters.
Notice
: do not shuffle the connectors.
- perform the simulation test.
Result:
2 Inspect ecm(igt1, igt2, igt3, igt4 and igf signal)
- Inspection using the oscilloscope.
- during cranking or idling, check the waveform between terminals igt1 to igt4 and e1, igf and e1 of the ecm connector.
Standard:
Hint
: correct waveform is as shown in the diagram on the left.
3 Check harness and connector(ignition coil assy – ecm)
- Disconnect the i2, i3, i4 or i5 ignition coil and igniter connector.
- disconnect the e3 ecm connector.
- check the resistance between the wire harness side connectors.
Standard (check for open):
Standard (check for open):
Standard (check for short):
Standard (check for short):
- Reconnect the ecm connector.
- reconnect the ignition coil and igniter connector
4 Inspect ignition coil assy(power source)
- Disconnect the i2, i3, i4 or i5 ignition coil and igniter connector.
- check the resistance between the wire harness side connectors.
Standard (check for open):
- Turn the ignition switch on position.
- measure the voltage between the terminal of the wire harness side connector and body ground.
Standard:
- Reconnect the ignition coil and igniter connector.
5 Check harness and connector(ignition coil assy – ignition switch)
- Disconnect the i2, i3, i4 or i5 ignition coil and igniter connector.
- disconnect the i10 ignition switch connector.
- check the resistance between the wire harness side connectors.
Standard (check for open):
Standard (check for short):
- Reconnect the ignition coil and igniter connector.
- reconnect the ignition switch connector.
Replace ignition coil assy
Other materials:
Pre–check
1. Diagnosis system
Release the parking brake lever.
check the warning lights.
When the ignition switch is turned on, check that the abs
warning light and brake warning light goes on for 3 sec.
Hint:
when the parking brake is applied or the level of the brake
fluid is low, the ...
Using the AUX port
This port can be used to connect a portable audio device and listen to it through
the vehicle’s speakers. Press until
“AUX” is displayed.
Connecting a portable player
■Operating portable audio devices connected to the audio system
The volume can be adjusted using the vehicle's ...
Using the radio (Multimedia system)
Radio operation
Select “AM” or “FM” on the audio source selection screen to begin listening
to the radio.
Audio control screen
Pressing the “AUDIO” button displays the audio control screen from any screens
of the selected source.
1 Audio source selection screen appears
2 Preset ...