Toyota Tacoma manuals

Toyota Corolla Repair Manual: Inspection procedure

Hint

: read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the air–fuel ratio was lean or rich, etc. At the time of the malfunction.

1 Read output dtc

  1. Clear the dtc.
  2.  warm up the engine.
  3.  run the engine at 3,000 rpm for 10 seconds or more.
  4.  connect the hand–held tester or the obd ii scan tool to the dlc3.
  5.  turn the ignition switch on and push the hand–held tester or the obd ii scan tool main switch on.
  6.  select the item ”diagnosis / enhanced obd ii / dtc info / current codes”.
  7.  read the dtcs.

Result :

2 Inspect knock sensor

2 Inspect knock sensor

  1. Check the knock sensor installation.

    Torque: 20 nvm (204 kgf·cm, 15 ftvlbf)

3 Check harness and connector(ecm – knock sensor)

3 Check harness and connector(ecm – knock sensor)

  1. Disconnect the e4 ecm connector.
  2.  measure the resistance between terminals of the e4 ecm connector.

Standard:

  1. Reconnect the ecm connector.

4 Inspect ecm(knk1 voltage)

4 Inspect ecm(knk1 voltage)

  1. Disconnect the e4 ecm connector.
  2.  turn the ignition switch on.
  3.  measure the voltage between terminals of the e4 ecm terminals.

Standard:

  1. Reconnect the ecm connector.

Check for intermittent problems

Check for intermittent problems

Notice

: fault may be intermittent. Check harness and connectors carefully.

5 Inspect knock sensor

  1. Remove the k1 knock sensor.
  2.  measure the resistance between the terminals.

Standard:

  1. Reinstall the knock sensor.

Repair or replace harness or connector

Repair or replace harness or connector

Circuit description
A flat type knock sensor (non–resonant type) has the structure that can detect the vibration in a wider band of frequency from about 6 khz to 15 khz and has the following features. Knock sensors ...

Crankshaft position sensor ”a” circuit
Dtc p0335 crankshaft position sensor ”a” circuit Dtc p0339 crankshaft position sensor ”a” circuit intermittent ...

Other materials:

On–vehicle inspection
1. Check basic function (manual operation function)  turn the ignition switch on.  Check that the door glass moves up when each window switch of the regulator master switch assembly is turned up and moves down when each window switch is turned down.  Check that the do ...

Inspection procedure
1 Check voltage at ig2 of airbag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector of the airbag sensor assy center.  connect the negative (–) terminal cable to the battery, and wait a ...

Using a Bluetooth® Phone
The hands-free system is a function that allows you to use your cellular phone without touching it. This system supports Bluetooth®. Bluetooth® is a wireless data system that allows the cellular phone to wirelessly connect to the hands-free system and make/receive calls. Before making a phon ...

© 2011-2024 Copyright www.tcorolla.net