Toyota Corolla (E120): Inspection procedure

Hint

: read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the air–fuel ratio was lean or rich, etc. At the time of the malfunction.

1 Check other dtc output(in addition to dtc p0101)

  1. Connect the hand–held tester or the obd ii scan tool to the dlc3.
  2.  turn the ignition switch on and push the hand–held tester or the obd ii scan tool main switch on.
  3.  select the item ”diagnosis / enhanced obd ii / dtc info / current codes”.
  4.  read the dtcs.

Result:

Hint:

Hint

: if any other codes besides p0101 are output, perform the troubleshooting for those dtcs first.

Go to relevant dtc chart

Go to relevant dtc chart

    Share this page:

    Other materials:

    Replacement
    Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove seat track upper rail cover rh 4. Remove seat track upper rail cover lh 5. Remove front seat assy lh 6. Remove seat position air bag sensor Disconnect the connector of the seat position airbag sensor. ...

    Check and replace ecu
    Notice: start an inspection of the connector from the backside of the connector on the wire harness side with the connector connected to the ecu. When no measurement condition is specified, perform the inspection with the engine stopped and also the ignition switch on. First check the ec ...

    Driving support system information display
    ■ Driving support system information Select to display the operational status of the following systems: Dynamic radar cruise control LTA (Lane Tracing Assist) LDA (Lane Departure Alert) ■ Navigation system-linked display (if equipped) Select to display the following navigation system-linked ...