Toyota Corolla (E120): Inspection procedure

1 Inspect dlc3 terminal voltage

  1. Turn the ignition switch to on.
  2.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3.

    Ok: voltage: 10 – 16 v

2 Check harness and connector(between cruise control ecu assy

2 Check harness and connector(between cruise control ecu assy and dlc3)

  1. Check for open and short circuit in harness and connector between cruise control ecu assy and dlc3

Check and replace cruise control ecu assy

Check and replace cruise control ecu assy

    Share this page:

    Other materials:

    Body
    On–vehicle inspection 1. Canada: tighten bolts and nuts on chassis and body  tighten the bolts and nuts on the chassis parts listed below, if necessary Front axle and suspension drive train rear axle and suspension brake system engine mounting other chassis parts ...

    Inspection procedure
    1 Check operation(starter) Check that the starter operates normally and that the engine starts. 2 Input signal check See input signal check on page 05–745.  check the indicator light when shifting into except d position. Ok: the indicator light goes off when shifting ...

    How to proceed with troubleshooting
    The hand–held tester can be used at step 3, 4, 6, 9. 1 Vehicle brought to workshop 2 Customer problem analysis 3 Connect the obd ii scan tool or hand–held tester to dlc3 4 Check and clear dtc and freeze frame data 5 Visual inspection 6 Setting the check mode diagnosis 7 Proble ...