Toyota Corolla (E120) 2002–2008 Repair Manual / Ignition / Inspection
Toyota Corolla (E120): Inspection
1. Spark plug
Notice
:
- never use a wire brush for cleaning.
- Never attempt to adjust the electrode gap on used spark plug.
- Spark plug should be replaced every 192,000 km (120,000 miles).
- Clean the spark plugs.
Air pressure: below 588 kpa (6.0 Kg/cm2, 85 psi) duration: 20 seconds or less
- Check the spark plug for thread damage and insulator damage.
Hint
: if abnormal, replace the spark plug.
Recommended spark plug:
sk16r11 (denso made)
ifr5a11 (ngk made)
- Check the spark plug electrode gap.
Electrode gap: 1.1 Mm (0.043 In.)
2. Crank position sensor no.1
- using an ohmmeter, measure the resistance between terminals.
Resistance:
at cold 835 – 1,400 w
at hot 1,060 – 1,645 w
N
otice
: ”cold” and ”hot” on the table express the temperature of the coils themselves. ”Cold” is from –10 c (14 f) to 50 c (122 f) and ”hot” is from 50 c (122 f) to 100 c (212 f).
Hint
: if the resistance is not as specified, replace the crank position sensor no. 1.
3. Crank position sensor
- using an ohmmeter, measure the resistance between terminals.
Resistance:
at cold 1,630 – 2,740 w
at hot 2,065 – 3,225 w
Notice
: ”cold” and ”hot” on the table express the temperature of the coils themselves. ”Cold” is from –10 c (14 f) to 50 c (122 f) and ”hot” is from 50 c (122 f) to 100 c (212 f).
Hint
: if the resistance is not as specified, replace the crank position sensor.
4. Ignition relay
- Continuity inspection.
- Using an ohmmeter, check that continuity exists between
each terminal.
Specified condition: between terminal 1 and 2 continuity between terminal 3 and 5 no continuity
- using an ohmmeter, check that continuity exists between terminals 3 and 5 when the battery voltage is applied across terminals 1 and 2.
Other materials:
Headlamp dimmer switch assy
Replacement
1. Remove steering column cover lwr
Remove 3 screws and steering column cover lwr.
2. Remove headlamp dimmer switch assy
Disconnect the connector.
release the claw and pull out the head light dimmer
switch assy.
...
Engine mechanical
Service data
Torque specification
...
Fuel system
Precaution
1. Before working on fuel system, disconnect negative (–) terminal cable
from
battery
2. Do not smoke or work near an open flame when working on fuel system
3. Keep gasoline away from rubber or leather parts
4. Work for prevent gasoline from spilling out
Remove the rear s ...