Toyota Corolla (E170): Inside rear view mirror

The rear view mirror’s position can be adjusted to enable sufficient confirmation of the rear view.

Share this page:

Other materials:

Hydraulic test
1. Perform hydraulic test Measure the line pressure. Notice: Do the test at normal operation atf temperature 50 to 80 °c (122 to 176 °f). The line pressure test should always be carried out in pairs. One technician should observe the conditions of wheels or wheel stopper outsi ...

General information
There are many ecu controlled systems used in the corolla. In general, ecu controlled system are considered to be very intricate and require a high level of technical knowledge and expert skill to troubleshoot. The fact is, however, that if you proceed by inspecting the circuits one by one, ...

Disposal
1. Dispose shock absorber assy front lh  fully extend the shock absorber piston rod.  using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside. Caution: when drilling, chips may fly out, work carefully. The gas is colorless, o ...