Toyota Corolla (E120): Input shaft assy (c59)

Share this page:

Other materials:

Adjustment
1. Inspect and adjust clutch pedal sub–assy Turn over the floor carpet.  check that the pedal height is correct. Pedal height from asphalt sheet: 135.8 – 145.8 Mm (5.346 – 5.740 In.)  adjust the pedal height. Loosen the lock nut and turn the stopper bolt until ...

Circuit description
In the diagram below, when the engine is cranked, current flows from terminal st2 of the ignition switch to the starter relay coil and also current flows to terminal sta of the ecm (sta signal). When the sta signal and ne signal are input to the ecm, tr is turned on, current flows to the c ...

Inspection procedure
1 Check p/t squib(rh) circuit(airbag sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...