Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Toyota vehicle intrusion protection system / Indicator light circuit
Toyota Corolla (E120): Indicator light circuit
Other materials:
Inspection procedure
1 Inspect ecm(+b voltage)
Turn the ignition switch on.
measure the voltage between the terminals of the e4 and
e6 ecm connectors.
Standard:
2 Check harness and connector(ecm – body ground)
Disconnect the e4 ecm connector.
check the resistance between the wire ...
Evap monitor (vacuum pressure monitor)
Notice:
a cold soak must be performed prior to conducting the drive pattern to complete
the internal pressure
readiness monitor.
Cold soak preconditions
The monitor will not run unless:
mil is off.
Fuel level is approximately 1/2 to 3/4.
Altitude is 7800 feet (2400 m) or less.
...
Inspection procedure
1 Check tvip ecu
Check that the operation of the tvip function is normal.
Hint:
with this inspection, the tvip ecu cpu can be diagnosed if it works normally or
not.
2 Check wire harness (tvip ecu integration relay)
Disconnect the tvip ecu and integration relay connectors.
ch ...