Toyota Corolla (E120): Ignition

Ignition system

Share this page:

Other materials:

Inspection procedure
1 Inspect fuse(ecu–ig fuse) Remove ecu–ig fuse from the instrument panel j/b.  check continuity of ecu–ig fuse. Ok: continuity 2 Inspect battery Ok: voltage: 10 – 14 v 3 Inspect skid control ecu connector(ig1 terminal voltage) In case of using hand–held te ...

Body rocker panel moulding lh
Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove body rocker panel moulding lh Remove the 8 retainers.  using a screwdriver, remove the moulding. Hint: tape the screwdriver tip before use.  remove the 7 clips from the moulding. 2. Insta ...

Inspection procedure
1 Check voltage at ig2 of airbag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector of the airbag sensor assy center.  connect the negative (–) terminal cable to the battery, and wa ...