Toyota Corolla (E170) 2014–2019 Owners Manual / When trouble arises / Essential information / If your vehicle has to be stopped in an emergency
Toyota Corolla (E170): If your vehicle has to be stopped in an emergency
Only in an emergency, such as if it becomes impossible to stop the vehicle in the normal way, stop the vehicle using the following procedure:
1 Steadily step on the brake pedal with both feet and firmly depress it.
Do not pump the brake pedal repeatedly as this will increase the effort required to slow the vehicle.
2 Shift the shift lever to N.
► If the shift lever is shifted to N
3 After slowing down, stop the vehicle in a safe place by the road.
4 Stop the engine.
► If the shift lever cannot be shifted to N
3 Keep depressing the brake pedal with both feet to reduce vehicle speed as much as possible.
4 Vehicles without a smart key system: Stop the engine by turning the engine switch to the “ACC” position.
4 Vehicles with a smart key system: To stop the engine, press and hold the engine switch for 2 consecutive seconds or more, or press it briefly 3 times or more in succession.
5 Stop the vehicle in a safe place by the road.
CAUTION
■If the engine has to be turned off while driving
●Power assist for the brakes and steering wheel will be lost, making the brake pedal harder to depress and the steering wheel heavier to turn.
Decelerate as much as possible before turning off the engine.
●Vehicles without a smart key system: Never attempt to remove the key, as doing so will lock the steering wheel.
Other materials:
Tape is tangled due to incorrect tape speed or
auto–reverse malfunction
Inspection procedure
1 Check for any foreign object
Check for any foreign object.
Check that no foreign material and troubles are detected in the radio
receiver assembly cassette
tape player.
Standard: no foreign material and trouble detected.
2 Replace cassette tape with an ...
Circuit description
Refer to dtc p0335
Dtc no.
Dtc detection condition
Trouble area
P0016
Deviation in crankshaft position sensor signal and camshaft
position sensor signal (2 trip detection logic)
Mechanical system (timing chain has jumped a tooth, chain
stretch ...
Inspection procedure
Hint:
hand–held tester only:
narrowing down the trouble area is possible by performing ”a/f control” active
test (heated oxygen
sensor or other trouble areas can be distinguished).
Perform active test using hand–held tester (a/f control).
Hint:
”a/f control” is the active te ...