Toyota Corolla (E170): If the engine will not start

If the engine will not start even though correct starting procedures are being followed , consider each of the following points:

The engine will not start even though the starter motor operates normally

.

One of the following may be the cause of the problem:

● There may not be sufficient fuel in the vehicle’s tank.

Refuel the vehicle.

● The engine may be flooded.

Try to restart the engine again following correct starting procedures.


● There may be a malfunction in the engine immobilizer system.

The starter motor turns over slowly, the interior lights and headlights are dim, or the horn does not sound or sounds at a low volume.

One of the following may be the cause of the problem:

● The battery may be discharged. ● The battery terminal connections may be loose or corroded.

The starter motor does not turn over (vehicles with a smart key system)

The engine starting system may be malfunctioning due to an electrical problem such as electronic key battery depletion or a blown fuse.

However, an interim measure is available to start the engine.

The starter motor does not turn over, the interior lights and headlights do not turn on, or the horn does not sound.

One of the following may be the cause of the problem:

● One or both of the battery terminals may be disconnected.

● The battery may be discharged. ● There may be a malfunction in the steering lock system.

Contact your Toyota dealer if the problem cannot be repaired, or if repair procedures are unknown.

Emergency start function (vehicles with a smart key system)

When the engine does not start, the following steps can be used as an interim measure to start the engine if the engine switch is functioning normally:

1 Set the parking brake.

2 Shift the shift lever to P (continuously variable transmission) or N (manual transmission).

3 Turn the engine switch to ACCESSORY mode.

4 Press and hold the engine switch for about 15 seconds while depressing the brake pedal and clutch pedal (manual transmission) firmly.

Even if the engine can be started using the above steps, the system may be malfunctioning. Have the vehicle inspected by your Toyota dealer.

    Share this page:

    Other materials:

    How to proceed with troubleshooting
    1 Vehicle brought to workshop 2 Customer problem analysis 3 Check and clear dtcs and freeze frame data 4 Problem symptom confirmation Symptom does not occur: go to step 5 Symptom occurs: go to step 6 5 Symptom simulation 6 Dtc check There is no output: go to step 7 There is outp ...

    Replacement
    Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove spare wheel cover assy 2. Remove rear floor finish plate Remove the 3 clips.  using a moulding remover, remove the rear floor finish plate. 3. Rem ...

    Heater & air conditioner
    Service data Torque specification Supplemental restraint system Torque specification Seat belt Torque specification Wiper & washer Torque specification Audio & visual system Torque specification Instrument panel/meter Torque specification Seat Torque sp ...