Toyota Corolla (E120) 2002–2008 Repair Manual / Introduction / How to troubleshoot ecu controlled
systems
Toyota Corolla (E120): How to troubleshoot ecu controlled systems
- General information
- How to proceed with troubleshooting
- Customer problem analysis
- Symptom confirmation and diagnostic trouble code
- Symptom simulation
- Diagnostic trouble code chart
- Problem symptoms table
- Circuit inspection
- Electronic circuit inspection procedure
Other materials:
Inspection procedure
Hand–held tester:
1 Perform active test by hand–held tester(operation of circuit
opening relay)
Connect the hand–held tester to the dlc3.
turn the ignition switch on and push the hand–held tester main
switch on.
select the item ”diagnosis / enhanced obd ii / active ...
If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle becomes
stuck in mud, dirt or snow:
1 Stop the engine. Set the parking brake and shift the shift lever to P (automatic
transmission or continuously variable transmission) or N (manual transmission).
2 Remove the mud, snow or s ...
Inspection procedure
1 Inspect park/neutral position switch assy
Disconnect the park/neutral position switch connector.
measure resistance according to the value(s) in the table
below when the shift lever is moved to each position.
Standard:
2 Check harness and connector(park/neutral position ...


