Toyota Corolla (E120): How to proceed with troubleshooting

1 Vehicle brought to workshop

2 Customer problem analysis

2 Customer problem analysis

3 Check and clear dtc

3 Check and clear dtc

4 Problem symptom confirmation

4 Problem symptom confirmation

Symptom does not occur (go to

Symptom does not occur (go to step 5)

5 Symptom simulation

6 Dtc check

6 Dtc check

7 Dtc chart

7 Dtc chart

8 Problem symptoms table

8 Problem symptoms table

9 Circuit inspection

9 Circuit inspection

10 Confirmation test

10 Confirmation test

End

End

Customer problem analysis check

Pre–check

    Share this page:

    Other materials:

    Overhaul
    1. Remove roof headlining assy 2. Remove sliding roof glass sub–assy  using a torx wrench (t25), remove the 4 screws the sliding roof glass.  pull the glass upward to remove it. 3. Remove sliding roof weatherstrip 4. Remove sliding roof drive gear sub–assy Notice: ...

    Tire & wheel
    Wheel and tire system Inspection 1. Inspect tire  check the tires for wear and proper inflation pressure. Cold tire inflation pressure: Using a dial indicator, check the tire runout. Tire runout: 3.0 Mm (0.118 In.) Or less 2. Rotate tire Hint: see the illustration ...

    Replacement
    Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove spare wheel cover assy 2. Remove rear floor finish plate Remove the 3 clips.  using a moulding remover, remove the rear floor finish plate. 3. Rem ...