Toyota Tacoma manuals

Toyota Corolla Repair Manual: How to proceed with troubleshooting

The hand–held tester can be used at step 4, 6, 8 and 9.

1 Vehicle brought to workshop

2 Customer problem analysis

2 Customer problem analysis

3 Warning light check

3 Warning light check

4 The dtcs check (present and past dtcs)

4 The dtcs check (present and past dtcs)

5 The dtcs chart

5 The dtcs chart

6 Circuit inspection

6 Circuit inspection

7 Repair

7 Repair

8 Clear the dtcs (present and past dtcs)

8 Clear the dtcs (present and past dtcs)

9 The dtcs check (present and past dtcs)

9 The dtcs check (present and past dtcs)

10 Symptom simulation

10 Symptom simulation

11 Confirmation test

11 Confirmation test

End

End

Customer problem analysis check

Pre–check

Supplemental restraint system
...

Pre–check
1. Srs warning light check Turn the ignition switch to the on position and check that the srs warning light lights up. check that the srs warning light goes out after approx. 6 Seconds ...

Other materials:

Replacement
1. Remove combination meter assembly 2. Disconnect brake master cylinder push rod clevis  remove the clip and push rod clevis pin and wave washer, and disconnect the push rod clevis from the brake pedal. 3. Remove brake pedal support sub–assy Remove the bolt from the brake ...

On–vehicle inspection
1. Inspect turn signal flasher relay circuit Disconnect the connector from the turn signal flasher relay and inspect the connector on wire harness side as shown in the chart. Standard: Connect the connector to the turn signal flasher and inspect the wire harness side connector ...

Inspection procedure
Hint Advanced timing over (valve timing is out of specified range) P0011 Retarded timing over (valve timing is out of specified range) P0012 If dtc p0011 or p0012 is displayed, check the vvt system circuit. Read freeze frame data using the hand–held tester or ...

© 2011-2024 Copyright www.tcorolla.net