The hand–held tester can be used at step 3, 4, 6, 9.
1 Vehicle brought to workshop
2 Customer problem analysis
3 Connect the obd ii scan tool or hand–held tester to dlc3
4 Check and clear dtc and freeze frame data
5 Visual inspection
6 Setting the check mode diagnosis
7 Problem symptom confirmation
Symptom does not occur: go to
step 8
Symptom occur: go to step 9
8 Symptom simulation
9 Dtc check
Dtc is not output: go to step 10
Dtc is output: go to step 18
10 Basic inspection
11 Mechanical system test
12 Hydraulic test
13 Manual shifting test
14 Problem symptoms table chapter 1
15 Problem symptoms table chapter 2
16 Problem symptoms table chapter 3
17 Part inspection
Go to step 20
18 Dtc chart
19 Circuit inspection
20 Identification of problem
21 Repair
22 Confirmation test
End
Replacement
1. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
2. Remove air cleaner cap sub–assy
3. Remove air cleaner case sub–assy
remove the air cleaner element, then remove the 3 bolts and air
cleaner case sub–assy.
4. ...
Removal & installation and disassembly & re
1. Remove bench type rear seat cushion assy (, 72–8)
2. Remove rear floor service hole cover
3. Work for preventing gasoline from spilling out
start the engine.
after the engine has stopped on the its own, turn the ignition
switch to lock.
4. Disconnect fuel tank main tube ...
Replacement
Hint: components:
1. Precaution
2. Disconnect battery negative terminal
3. Remove seat track upper rail cover rh
4. Remove seat track upper rail cover lh
5. Remove front seat assy lh
6. Remove seat position air bag sensor
Disconnect the connector of the seat position airbag sensor. ...