1 Display the “Bluetooth* Setup” screen. 2 Select “System Settings”.
3 The following screen is displayed:
1 Bluetooth® Power on/off
You can change Bluetooth® function on/off
2 Bluetooth® Name
3 Change PIN-code
4 Bluetooth® Address
5 Display Phone Status
You can set the system to show the status confirmation display when connecting a
telephone
6 Display Audio Player Status
You can set the system to show the status confirmation display when connecting an
audio player
7 Compatibility profile of the system
8 Restore default settings
*: Bluetooth is a registered trademark of Bluetooth SIG, Inc.
Inspection procedure
1 Check side air bag sensor assy lh
Sst 09843–18040
Connect the negative (–) terminal cable to the battery,
and wait at least for 2 seconds.
turn the ignition switch to on, and wait at least for 20 seconds.
clear the dtc stored in memory .
turn the ignition switch ...
Inspection procedure
1 Inspect park/neutral position switch assy
Disconnect the park/neutral position switch connector.
measure resistance according to the value(s) in the table
below when the shift lever is moved to each position.
Standard:
2 Check harness and connector(park/neutral position ...
Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal)
Turn the ignition switch to on.
measure voltage between terminals tc and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector between ...