Toyota Corolla Repair Manual: Heater control & accessory assy
Replacement
1. Remove console panel upper
2. Remove instrument cluster finish panel
3. Remove heater control & accessory assy
- Release the 2 fitting claws and pull out the heater control
& accessory assy.
- Using a screwdriver, open the claw of the cable clamp and
disconnect the defroster damper control cable.
Notice
:
- be careful not to bend the cable wire.
- If the cable wire bends, the heater control & accessory
assy operationality becomes worse.
Hint
:
tape the screwdriver tip before use.
- Using a screwdriver, open the claw of the cable clamp and
disconnect the air mix damper control cable.
Notice
:
- be careful not to bend the cable wire.
- If the cable wire bends, the heater control & accessory
assy operationality becomes worse.
Hint
:
tape the screwdriver tip before use.
- disconnect the connector, remove the heater control &
accessory assy.
4. Install heater control & accessory assy
- Install the inner cable end of the air mix damper control
cable to the heater control lever.
- install the outer cable of the air mix damper control cable
to the cable clamp.
Notice
:
- be careful not to bend the cable wire.
- If the cable wire bends, the heater control & accessory
assy operationality becomes worse.
Hint
:
- operating the heater control knob and check that it properly
stops at both ends of max. Cool and max. Hot
and no recoil is identified.
- Check that the outer cable should not be disengaged
(moved) from the heater control & accessory assy when
the cable is pulled.
- Install the inner cable end of the defroster damper control
cable to the heater control lever.
- install the outer cable of the defroster damper control
cable to the cable clamp.
Notice
:
- be careful not to bend the cable wire.
- If the cable wire bends, the heater control & accessory
assy operationality becomes worse.
Hint
:
- operating the heater control knob and check that it properly
stops at both ends of face and def and no recoil is
identified.
- Check that the outer cable should not be disengaged
(moved) from the heater control & accessory assy when
the cable is pulled.
- connect the connector, install the heater control & accessory
assy.
Other materials:
Circuit description
The side airbag sensor assy (lh) circuit consists of the diagnosis circuit
and lateral deceleration sensor, etc.
It receives signals from the lateral deceleration sensor, judges whether or not
the srs must be activated,
and detects diagnosis system malfunction.
Dtc b1141/33 is recorded wh ...
Overhaul
Hint:
overhaul the rh side by the same procedures with lh side.
1. Remove rear wheel
2. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
3. Remove rear brake drum sub–assy
Release the parking brake lever, and remove the ...
Removal & installation and disassembly & reassembly
1. Remove bench type rear seat cushion assy
2. Remove rear floor service hole cover
Remove the rear service hole cover.
Disconnect the fuel pump and vapor pressure sensor
connector.
3. Work for preventing gasoline from spilling out
Start the engine.
after the engi ...