Toyota Corolla (E120): Heater & air conditioner

Preparation

Sst

Recomended tools

Recomended tools

Equipment

Equipment

Lubricant

Lubricant

Supplemental restraint system

    Share this page:

    Other materials:

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector between the airbag sensor assy center and the instrument panel ...

    If your vehicle overheats
    The following may indicate that your vehicle is overheating. ● Vehicles without a multi-information display: The high engine coolant temperature warning light  comes on or a loss of power is experienced. Vehicles with a multi-information display: The engine coolant temperature gauge&n ...

    On–vehicle inspection
    1. Inspect air–fuel ratio compensation system Hint: you can also check the system by choosing ”data monitor”, then ”o2 sensor output voltage” on the monitor of the hand–held tester. Connect the hand–held tester to the terminal 23 (ox1a) @ 7 (e1) and 21 (ox1b) @ 7 (e1) of ...