Toyota Corolla (E120): Hazard warning switch circuit

Share this page:

Other materials:

Inspection procedure
1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

Circuit description
The crankshaft position sensor (ne signal) consists of a magnet, iron core and pickup coil. The ne signal plate (crankshaft position sensor plate) has 34 teeth and is installed on the crankshaft. The ne signal sensor generates 34 signals for each engine revolution. This sensor monitors a p ...

Inspection procedure
Hand–held tester: 1 Perform active test by hand–held tester(operation of circuit opening relay) Connect the hand–held tester to the dlc3.  turn the ignition switch on and push the hand–held tester main switch on.  select the item ”diagnosis / enhanced obd ii / active ...