Toyota Corolla (E120): Harf connection in airbag sensor assy connector

Dtc b1135/24 harf connection in airbag sensor assy connector

Share this page:

Other materials:

On–vehicle inspection
1. Check cooling fan operation with low temperature (below 83 c (181 f)) Turn the ignition switch on.  check that the cooling fan stops. Hint: if not, check the cooling fan relay and water temperature sensor, and check for separated connector or severed wire between the cooling fan ...

Turning on the high beam headlights
1 With the headlights on, push the lever away from you to turn on the high beams. Pull the lever toward you to the center position to turn the high beams off. 2 Pull the lever toward you and release it to flash the high beams once. You can flash the high beams with the headlights on or off. &# ...

Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...