Toyota Corolla (E120) 2002–2008 Repair Manual / Introduction / Repair instruction / Precaution / Handling of hose clamps
Toyota Corolla (E120): Handling of hose clamps
- Before removing the hose, check the depth of the inserting portion and the clamp position in order to restore it surely.
- change a deformed or dented clamp for a new one.
- in case of reusing the hose, install the clamp on the hose where it has a clamp track.
- for a spring type clamp, adjust it by adding force to the arrow mark direction after the installation.
Other materials:
Check dlc3
The vehicle’s ecm uses the iso 9141–2 for communication
protocol. The terminal arrangement of the dlc3 complies
with sae j1962 and matches the iso 9141–2 format.
Hint:
if the display shows unable to connect to vehicle
when you have connected the cable of the obd ii scan tool or
the h ...
Check open circuit
For the open circuit in the wire harness in fig. 1, Perform
a resistance check in step (b) or a voltage check in step
(c) to locate the section.
Check the resistance.
Disconnect connectors a and c and measure the
resistance between them.
Resistance: 1 Ω or les ...
Registering a Bluetooth® device
Before using the Bluetooth® audio/phone, it is necessary to register a Bluetooth®
device in the system. You can register up to 5 Bluetooth® devices.
How to register a Bluetooth® device
1 Press and select “Bluetooth*”
using .
2 Press and select “BT Pairing”
using .
A passkey w ...