Toyota Corolla (E120): Glass breakage sensor circuit

Share this page:

Other materials:

Seat belt warning lamp for front passenger’s seat does not flash
Wiring diagram Inspection procedure 1 Inspect combination meter assy Ground terminal c9–11 on the combination meter side.  check that the warning lightlights up. Ok: warning light lights up. 2 Inspect passenger seat belt warning lamp assy Ground terminal c9– ...

Temporarily engaged gear steps selection mode in the D position
To drive in temporary gear steps selection mode, operate the “-” and “+” paddle shift switches. The gear steps can then be selected by operating the “-” and “+” paddle shift switches. By selecting gear step using paddle shift switches, you can control engine braking forces. 1 ...

Overhaul
1. Remove generator pulley Sst 09820–63010 (09820–06010, 09820–06020) Hint: Hold sst 1 – a with a torque wrench, and tighten sst 1 – b clockwise to the specified torque. Torque: 39 nvm (398 Kgf·cm, 29 ft·lbf) Notice: check that sst is secured to the rotor shaft. ...