Toyota Corolla (E170): General settings

Settings are available for adjusting the operation sounds, screen animation, etc.

Share this page:

Other materials:

Inspection procedure
1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...

Replacement
1. Remove battery 2. Remove battery carrier Remove the 4 bolts and battery carrier. 3. Disconnect floor shift cable transmission control shift Remove the nut from the control shaft lever.  disconnect the control cable from the control shaft lever.  remove the clip a ...

Terminals of ecu
1. Inspect tvip ecu Inspect the ecu–b, dome and ecu–ig fuses. disconnect the tvip ecu connector, and the continuity and voltage of check each terminal of the disconnected connector. Standard: If the result is not as specified, the vehicle’s side may malfunction. Reco ...