Toyota Corolla (E170): General maintenance

Listed below are the general maintenance items that should be performed at the intervals specified in the “Owner’s Warranty Information Booklet” or “Owner’s Manual Supplement/Scheduled Maintenance Guide”. It is recommended that any problem you notice should be brought to the attention of your Toyota dealer or qualified service shop for advice.

Share this page:

Other materials:

Skid control sensor
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...

For vehicles equipped with mobile communication system
Install an antenna as far as possible away from the ecu and sensors of the vehicle’s electronic systems.  install an antenna feeder at least 20 cm (7.87 In.) Away from the ecu and sensors of the vehicle’s electronic systems. For details of the ecu and sensors locations, refer ...

Combination meter assy
Overhaul Hint: components: 1. Remove meter hood sub–assy 2. Remove combination meter assy Remove the screw.  disengage the 2 clips as shown in the illustration.  disconnect the connector, then remove the combination meter. 3. Remove combination meter glass Di ...