Toyota Corolla (E120): Fuel pump control circuit

Share this page:

Other materials:

Replacement
1. Remove engine under cover rh 2. Remove fan and generator v belt 3. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  disconnect the alternator connecto ...

Inspection procedure
1 Input signal check See input signal check on page 05–745. check the indicator light operation when each of the set/ coast, resume/accel and cancel is turned on. Ok: set/coast, resume/accel switch: the signals shown in the table on the left should be output when each switch is ...

Using the dynamic radar cruise control
Setting the vehicle speed 1. Press the driving assist mode select switch to select dynamic radar cruise control. The dynamic radar cruise control indicator will illuminate. 2. Using the accelerator pedal, accelerate or decelerate to the desired vehicle speed (approximately 20 mph [30 km/h] or more ...