Toyota Corolla (E120): Front suspension

Share this page:

Other materials:

Inspection procedure
Hand–held tester: 1 Perform active test by hand–held tester(operation of circuit opening relay) Connect the hand–held tester to the dlc3.  turn the ignition switch on and push the hand–held tester main switch on.  select the item ”diagnosis / enhanced obd ii / active ...

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Inspection procedure
1 Check seat position air bag sensor Sst 09843–18040 Turn the ignition switch to on, and wait at least for 20 seconds.  clear the dtc stored in memory .  turn the ignition switch to lock, and wait at least for 20 seconds.  turn the ignition switch to on, and wait at ...