Toyota Corolla (E120): Front door belt moulding assy lh

Replacement

Hint

:

  • the installation procedures are the removal procedures in reverse order.
  • Use the same procedures for the rh side and lh side.

1. Remove front armrest assy lh

2. Remove power window regulator master switch assy (w/ power window)

3. Remove front armrest base panel upper lh (w/o power window)

4. Remove front door window regulator handle assy (w/o power window)

5. Remove front door lower frame bracket garnish lh

6. Remove front door trim board sub–assy lh

7. Remove front door belt moulding assy lh

  1. Put protective tape under the weatherstrip.
  2.  using a moulding remover, pry out the weatherstrip as shown in the illustration.

Hint

: tape the moulding remover tip before use.

    Share this page:

    Other materials:

    Inspection procedure
    1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the horn button assy and the airbag sensor assy center.  for the blac ...

    Vehicle control system
    Ignition or starter switch assy Replacement 1. Remove steering column cover 2. Remove ignition or starter switch assy Disconnect the ignition switch connector and unlock warning switch connector.  remove the 2 clamps.  remove the 2 screws and ignition switch. Inspectio ...

    Circuit description
    The ignition switch provides circuit power and the ecm provides the circuit ground that illuminates the mil. Mil operation is checked visually: it should be illuminated when the ignition is first turned on. If the mil is off all of the time or on all of the time, use the procedure below to ...