This repair manual has been prepared to provide essential information on body panel repair methods (including cutting and welding operations, but excluding painting) for the toyota corolla
Applicable models: aze141 series zre142 series
This manual consists of body repair methods, exploded diagrams and illustrations of the body components and other information relating to body panel replacement such as handling precautions, etc. However, it should be noted that the front fenders of the toyota model is bolted on and require no welding.
When repairing, don’t cut and join areas that are not shown in this manual. Only work on the specified contents to maintain body strength.
Body construction will sometimes differ depending on specifications and country of destination. Therefore, please keep in mind that the information contained herein is based on vehicles for general destinations.
For the repair procedures and specifications other than collisiondamaged body components of the toyota corolla refer to the repair manuals.
If you require the above manuals, please contact your toyota dealer.
All information contained in this manual is the most up-to-date at the time of publication. However, specifications and procedures are subject to change without prior notice.
About this manual
Scope of the repair work explanation
We have abbreviated the explanations of the removal and reinstallation of the equipment parts up to the white body condition and of the installation, inspection, adjustment and final inspection of equipment parts after replacing the weld panel.
Section categories
Section title | Contents | Examples |
Introduction | Explanation of general body repair.
Views of weld panel replacement instructions. |
Precaution about this vehicle |
Body panel replacement | Instructions for replacing the weld panels from the white body condition, from which bolted parts have been removed, with individual supply parts. | Front side member replacement.
Quarter panel replacement. |
Body dimensions | Body aligning measurements | Dimension diagrams. |
Paint coating | Scope and type of anti-rust treatment, etc.
Together with weld panel replacement |
Body sealer.
Under coat. |
Contents omitted in this manual
Check mode procedure
1. Dtc check (check mode)
Hint:
hand–held tester only:
compared to the normal mode, the check mode has more sensing
ability to detect malfunctions. Furthermore, the same diagnostic
items which are detected in the normal mode can also be
detected in the check mode.
Procedure for check mod ...
Coasting
Concept
Under certain conditions the engine is automatically
decoupled from the transmission in the D
selector lever position. The vehicle continues
traveling with the engine idling to reduce consumption.
Selector lever position D remains engaged.
This driving condition is referred to as coasting. ...
For vehicles equipped with catalytic converter
Caution:
if large amount of unburned fuel flows into the converter, it may cause
overheating and a fire hazard.
To prevent this, observe the following precautions.
Use only unleaded gasoline.
avoid prolonged idling.
Avoid running the engine at idle speed for more than 20 minutes. ...