Toyota Corolla (E170): For safety and security

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...

Replacement
1. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 2. Remove front wheel rh 3. Remove front fender liner rh 4. Remove brake actuator with bracket  turn the latch of the actuator connector to disconnect the connector. ...

Replacement
Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove spare wheel cover assy 2. Remove rear floor finish plate Remove the 3 clips.  using a moulding remover, remove the rear floor finish plate. 3. Rem ...