Toyota Corolla (E140): Foamed material application areas

If an increase in temperature or other condition damages the foamed material when repairing or replacing the panel, fill in the insufficient areas with urethane foam. The following illustration shows the areas for one side, but the foamed material must be applied equally to both the left and right sides.

Hint:

  1.  work must be performed while wearing the appropriate protective gear and in a will-ventilated area.
  2.  Apply tape or equivalent to any holes, nuts, etc., Near the areas to be filled.

Body panel anti-rust agent (wax) application areas

    Share this page:

    Other materials:

    No sound is heard from speaker in all modes
    Wiring diagram Inspection procedure 1 Check lcd (liquid crystal display) for lighting Lcd illumination check  turn the ignition switch acc.  Turn the radio receiver assembly on. Standard: lcd illumination of the radio receiver assembly light. 2 Control fader and ...

    Emission inspection and maintenance (I/M) programs
    Some states have vehicle emission inspection programs which include OBD (On Board Diagnostics) checks. The OBD system monitors the operation of the emission control system. If the malfunction indicator lamp comes on The OBD system determines that a problem exists somewhere in the emission cont ...

    Outside vehicle
    General maintenance Performing these maintenance checks on the vehicle in the owner’s responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In most cases, special tool are not requir ...