Replacement
1. Precaution
2. Disconnect battery negative terminal
3. Remove parking brake hole cover sub–assy
4. Remove console panel upper
5. Remove console box carpet
6. Remove console box sub–assy rear
7. Remove air bag sensor assy center
8. Disconnect oxygen sensor connector
9. Remove floor panel brace front
10. Remove exhaust pipe assy front
11. Remove front floor heat insulator no.1
12. Remove air cleaner case
13. Remove air cleaner hose no.1
14. Remove floor shift cable transmission control shift
15. Install floor shift cable transmission control shift
Torque: 5.0 Nvm (50 Kgf·cm, 43 in.Vlbf)
Hint
: install it with the uneven surface facing upward.
Torque: 12 nvm (122 Kgf·cm, 9 ft·lbf)
16. Install air cleaner case
17. Install front floor heat insulator no.1
Torque: 5.5 Nvm (56 Kgf·cm, 49 in.Vlbf)
18. Install exhaust pipe assy front
19. Install floor panel brace front
Torque: 29.6 Nvm (302 Kgf·cm, 22 ft·lbf)
20. Install oxygen sensor connector
21. Install air bag sensor assy center
22. Adjust shift lever position
23. Inspect shift lever position
24. Inspect srs warning light
Overhaul
1. Remove control shift lever bush
Remove the control shift lever bush from the selecting
bellcrank assy.
2. Remove selecting bellcrank dust cover no.1
Remove the selecting bellcrank dust cover no.1 From the
selecting bellcrank assy.
3. Remove selecting bell crank no.2
...
Inspection procedure
1 Check side squib(lh) circuit(airbag sensor assy center – front
seat airbag assy lh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the front seat airbag assy (lh ...
Seat belt warning lamp for front passenger’s seat
does not flash
Wiring diagram
Inspection procedure
1 Inspect combination meter assy
Ground terminal c9–11 on the combination meter side.
check that the warning lightlights up.
Ok: warning light lights up.
2 Inspect passenger seat belt warning lamp assy
Ground terminal c9–6 on ...