Toyota Corolla (E170): Fastening and releasing the seat belt

1 To fasten the seat belt, push the plate into the buckle until a click sound is heard.

2 To release the seat belt, press the release button.

Adjusting the seat belt shoulder anchor height (front seats)

    Share this page:

    Other materials:

    Malfunction in speedometer
    Wiring diagram Inspection procedure 1 Check combination meter assy Remove the combination meter assy with connector still connected.  check voltage.  Jack up either of the front wheels.  Shift the shift lever to neutral.  Turn the ignition switch to on ...

    Disposal
    1. Dispose shock absorber assy front lh  fully extend the shock absorber piston rod.  using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside. Caution: when drilling, chips may fly out, work carefully. The gas is colorless, o ...

    Replacement
    1. Remove engine under cover rh 2. Remove fan and generator v belt 3. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  disconnect the alternator connecto ...