Toyota Corolla (E170): Fast-forwarding and reversing a file

To fast-forward or reverse, press and hold ) or ( () or ). ( Repeat play).

    Share this page:

    Other materials:

    Inspection procedure
    Hint: troubleshoot each trouble symptom in accordance with the chart below. 1 Clear dtc Connect the hand–held tester or the obd ii scan tool to the dlc 3.  turn the ignition switch on and push the hand–held tester or the obd ii scan tool main switch on.  read the dtc . ...

    Replacement
    1. Remove engine under cover rh 2. Remove fan and generator v belt 3. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  disconnect the alternator connecto ...

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...