Toyota Corolla (E120) 2002–2008 Repair Manual / Exterior/interior trim
Toyota Corolla (E120): Exterior/interior trim
- Front bumper
- Rear bumper
- Rear spoiler
- Out side moulding
- Front door belt moulding assy lh
- Rear door belt moulding assy lh
- Body rocker panel moulding lh
- Side mudguard sub–assy lh
- Luggage compartment door garnish outside
- Roof drip side finish moulding center lh
- Roof headlining assy
Other materials:
Inspection procedure
Hand–held tester:
1 Perform active test by hand–held tester(operation of circuit
opening relay)
Connect the hand–held tester to the dlc3.
turn the ignition switch on and push the hand–held tester main
switch on.
select the item ”diagnosis / enhanced obd ii / active ...
Hydraulic test
1. Perform hydraulic test
Measure the line pressure.
Notice:
Do the test at normal operation atf temperature 50 to 80 °c (122 to
176 °f).
The line pressure test should always be carried out in pairs. One
technician should observe
the conditions of wheels or wheel stopper outsi ...
Inspection procedure
1 Check voltage at ig2 of airbag sensor assy center
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connector of the airbag sensor assy center.
connect the negative (–) terminal cable to the battery,
and wa ...