Toyota Corolla (E210): Before driving

Observe the following before starting off in the vehicle to ensure safety of driving.

Floor mat

Use only floor mats designed specifically for vehicles of the same model and model year as your vehicle. Fix them securely in place onto the carpet.

1. Insert the retaining hooks (clips) into the floor mat eyelets.

2. Turn the upper knob of each

2. Turn the upper knob of each retaining hook (clip) to secure the floor mats in place.

Always align the  marks A.

Always align the The shape of the retaining hooks marks A.

The shape of the retaining hooks (clips) may differ from that shown in the illustration.

WARNING

Observe the following precautions.

Failure to do so may cause the driver's floor mat to slip, possibly interfering with the pedals while driving. An unexpectedly high speed may result or it may become difficult to stop the vehicle.

This could lead to an accident, resulting in death or serious injury.

■When installing the driver's floor mat

  • Do not use floor mats designed for other models or different model year vehicles, even if they are Toyota Genuine floor mats.
  • Only use floor mats designed for the driver's seat.
  • Always install the floor mat securely using the retaining hooks (clips) provided.
  • Do not use two or more floor mats on top of each other.
  • Do not place the floor mat bottom- side up or upside-down.

■Before driving

  • Check that the floor mat is securely fixed in the correct place with all the provided retaining hooks (clips). Be especially careful to perform this check after cleaning the floor.

  • With the engine stopped and the shift lever in P, fully depress each pedal to the floor to make sure it does not interfere with the floor mat.
    Share this page:

    Other materials:

    Stabilizer bar front
    Replacement Hint: components: 1. Remove front wheel 2. Remove front stabilizer link assy lh Remove the 2 nuts and stabilizer bar link. Hint: if the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud. 3. Remove front stabilizer link assy rh Hint: ...

    Inspection procedure
    1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector between the airbag sensor assy center and the horn button assy.  for the black ...

    Folding the mirrors
    Push the mirror back in the direction of the vehicle’s rear. ■Mirror angle can be adjusted when ► Vehicles without a smart key system The engine switch is in the “ACC” or “ON” position. ►Vehicles with a smart key system The engine switch is in ACCESSORY or IGNITION ...