Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Evaporative emission control system pressure sensor

Toyota Corolla (E120): Evaporative emission control system pressure sensor

Dtc p0451 evaporative emission control system pressure sensor range/performance

Dtc p0452 evaporative emission control system pressure sensor/switch low input

Dtc p0453 evaporative emission control system pressure sensor/switch high input

Share this page:

Other materials:

Inspection procedure
1 Check ignition or starter switch assy Check the ignition switch, as shown in the illustration and table. Standard: 2 Check fuse (ecu–b) Remove the fuse from the instrument panel j/b.  check the continuity of the fuse. Standard: continuity 3 Check relay (m ...

Checking and adding the brake fluid
■ Checking fluid level The brake fluid level should be between the "MAX" and "MIN" lines on the tank. ■ Adding fluid 1. Slide and lift up the rubber strip to partly remove it as shown. 2. Disconnect the claws and remove the service cover. 3. Remove the reservoir cap. 4. Add brake fluid slowl ...

On–vehicle inspection
1. Install lspv gauge (sst) and bleed air  remove the bleeder plugs from the front and rear brake cylinder.  install the lspv gauge (sst), and bleed the air. Sst 09709–29018 2. Raise master cylinder pressure and check rear wheel cylinder pressure Hint: when inspectin ...