Toyota Corolla (E120) 2002–2008 Repair Manual / Preparation / Engine hood/door
Toyota Corolla (E120): Engine hood/door
Preparation
Sst

Recomended tools

Equipment

Other materials:
Circuit description
The camshaft position sensor (g22+ signal) consists of a magnet, iron core
and pickup coil.
The g22+ signal plate has 3 teeth on its outer circumference and is installed on
the camshaft timing pulley.
When the camshafts rotate, the protrusion on the signal plate and the air gap on
the pi ...
Overhaul
Hint: components:
1. Remove rear wheel
2. Remove spare wheel cover assy
3. Remove rear floor finish plate
4. Remove luggage compartment trim cover inner lh
5. Remove rear shock absorber with coil spring
Support the rear axle beam with jack.
Remove the 2 nuts and bolt.
...
Outside vehicle
General maintenance
Performing these maintenance checks on the vehicle in the owner’s
responsibility. The owner may
perform the maintenance or take the vehicle to a service center.
Check the parts of the vehicle described below on a daily basis. In most cases,
special tool are not
requir ...


