Toyota Corolla (E170): Engine compartment

Vehicle interior

    Share this page:

    Other materials:

    Circuit description
    In the diagram below, when the engine is cranked, current flows from terminal st2 of the ignition switch to the starter relay coil and also current flows to terminal sta of the ecm (sta signal). When the sta signal and ne signal are input to the ecm, tr is turned on, current flows to the c ...

    Replacement
    Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove front door scuff plate rh 4. Remove rear door scuff plate rh 5. Remove front door opening trim rh 6. Remove rear door opening trim rh 7. Remove lap belt outer anchor cover 8. Remove center pillar garnis ...

    Inspection procedure
    1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...