Toyota Corolla (E120): Engine
On–vehicle inspection
Hint
: inspect these items on a cooled down engine.
1. Inspect drive belt
2. Replace spark plugs
3. Inspect air filter
- Remove the air filter.
- visually check that the air filter is not excessively damaged,
dirty or oily.
Peplace the air filter if necessary.
- clean the filter with compressed air.
First blow from the inside of the filter thoroughly then repeat from the outside.
- reinstall the air filter.
4. Replace air filter
- replace the air filter with a new one.
5. Replace engine oil and oil filter
6. Replace engine coolant
7. Inspect gasket in fuel tank cap
8. Inspect fuel lines and connections, fuel tank vapor vent system hoses and fuel tank bands
- visually check the fuel lines for cracks, leakage, loose connections, deformation and tank band looseness.
9. Inspect exhaust pipes and mountings
- visually check the pipes, hangers and connections for severe corrosion, leaks and damage.
10. Inspect valve clearance
Other materials:
On–vehicle inspection
1. Check fuel pump operation
Connect the hand–held tester to the dlc3.
turn the ignition switch on and hand–held tester main
switch on.
Notice:
do not start the engine.
select the active test mode on the hand–held tester.
please refer to the hand–held te ...
Basic inspection
When the malfunction is not confirmed in the dtc check, troubleshooting
should be carried out in all the
possible circuits considered as causes of the problem. In many cases, by
carrying out the basic engine check
shown in the following flowchart, the location causing the problem can be found ...
Replacement
1. Disconnect battery negative terminal
2. Remove engine under cover rh
3. Remove starter assy
Disconnect the starter connector.
open the terminal cover.
remove the nut, then disconnect the starter wire.
remove the 2 bolts, then remove the starter.
4. Install starter a ...