Toyota Corolla (E120): Emission control system

Share this page:

Other materials:

Catalyst monitor (o2s type)
Preconditions The monitor will not run unless: mil is off. Engine coolant temperature (ect) is 176°f (80 °C) or greater. Intake air temperature (iat) is 14°f (–10 °C) or greater.* Notice: * 2002 and later my vehicles: the readiness test can be completed in cold ambient c ...

Skid control sensor
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...

Wiring diagram
1 Inspect terminal voltage(pi) (a) turn Turn the ignition switch to on.  measure voltage between terminal 5 (pi) of cruise control ecu assy and body ground, when the cruise control main switch button is on and off. Ok: 2 Inspect combination meter assy 3 Check harn ...