Toyota Corolla (E120) 2002–2008 Repair Manual / Emission control
Toyota Corolla (E120): Emission control
- Emission control system
- Engine assembly
- Fan and generator v belt
- Valve clearance
- Partial engine assy
- Chain sub–assy
- Camshaft
- Cylinder head gasket
- Timing gear cover oil seal
- Engine rear oil seal
- Cylinder head assy
- Cylinder block assy
Other materials:
Inspection procedure
1 Check operation(overdrive)
Drive the vehicle after the engine warms up.
check that overdrive on e off occurs by an operation of the o/d
switch on–off.
2 Inspect terminal voltage(od)
Remove the cruise control ecu assy with the connector
still connected.
tur ...
Overhaul
Notice: when installing, coat the parts indicated by the arrow with
power steering fluid or molybdenum disulfide lithium base grease.
1. Precaution
2. Disconnect battery negative terminal
3. Inspect center front wheel
4. Remove horn button assy
5. Remove steering wheel assy
sst 09950–50013 ...
Inspection procedure
1 Check hazard warning signal switch assy
Check the hazard warning switch continuity, as shown in
the illustration and table.
Standard:
2 Check turn signal flasher assy
3 Check wire harness (tvip ecu turn signal flasher)
Disconnect the tvip ecu and turn signal flashe ...