Toyota Corolla (E120): Ecu power source circuit

Share this page:

Other materials:

On–vehicle inspection
1. Inspect w/receiver condenser assy  if a fin of the w/receiver condenser assy is dirty, clean it with water and dry it with compressor air. Notice: do not damage the fin of the w/receiver condenser assy.  if a fin of the w/receiver condenser assy is bent, make it straig ...

If the engine will not start
If the engine will not start even though correct starting procedures are being followed , consider each of the following points: The engine will not start even though the starter motor operates normally. One of the following may be the cause of the problem: ● There may not be sufficient f ...

Inspection procedure
1 Inspect shift solenoid valve(sl) Remove the shift solenoid valve sl.  measure the resistance according to the value(s) in the table below. Standard: Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the so ...