Toyota Corolla (E170) 2014–2019 Owners Manual / Driving / Driving procedures / Continuously variable transmission (vehicles without paddle shift switches) / Eco drive mode (if equipped)
Toyota Corolla (E170): Eco drive mode (if equipped)
Press the switch.
Suitable for enhancing the fuel economy, because the torque corresponding to the accelerator pedal depression amount can be generated more smoothly than it is in normal conditions and the operation of the air conditioning system (heating/cooling) will be minimized.
Press the switch again to return to normal mode.
■When driving with cruise control activated
Even when performing the following actions with the intent of enabling engine braking, engine braking will not activate while downshifting to S because cruise control will not be canceled. ■If the shift lever cannot be shifted from P
CAUTION
■When driving on slippery road surfaces
Be careful of downshifting and sudden acceleration, as this could result in the vehicle skidding to the side or spinning.
Other materials:
Inspection procedure
Hand–held tester:
1 Perform active test by hand–held tester(operation of circuit
opening relay)
Connect the hand–held tester to the dlc3.
turn the ignition switch on and push the hand–held tester main
switch on.
select the item ”diagnosis / enhanced obd ii / active ...
Replacement
1. Remove battery
2. Remove battery carrier
Remove the 4 bolts and battery carrier.
3. Disconnect floor shift cable transmission control shift
Remove the nut from the control shaft lever.
disconnect the control cable from the control shaft lever.
remove the clip a ...
Inspection procedure
1 Check security indicator light
Set the system in 30 seconds after filliping the security indicator to
check if the alarm is triggered.
2 Check glass breakage sensor ecu (glass breakage sensor)
Check the continuity and voltage of the glass breakage
sensor ecu, as shown in th ...