Toyota Tacoma manuals

Toyota Corolla Repair Manual: Ecm/pcm processor

Dtc p0606 ecm/pcm processor

Monitor description

The ecm continuously monitors its internal circuits. This self–check insures that the ecm is functioning properly.

If a malfunction is detected, the ecm will set the appropriate dtc and illuminate the mil.

The two cpus, main and sub cpu inside the ecm, perform continuous mutual monitoring. If there is difference between outputs from the two cpus that deviates from standard level ranges, the ecm concludes that there is a fault and sets a dtc.

Monitor strategy

Monitor strategy

Typical enabling conditions

Typical enabling conditions

Typical malfunction thresholds

Typical malfunction thresholds

Inspection procedure

Inspection procedure

Hint

: read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the air–fuel ratio was lean or rich, etc. At the time of the malfunction.

Replace ecm

Inspection procedure
Hint: read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is usefu ...

Starter relay circuit high
Dtc p0617 starter relay circuit high ...

Other materials:

Wireless remote control/electronic key battery
Replace the battery with a new one if it is depleted. You will need the following items: ● Flathead screwdriver ● Small flathead screwdriver ● Lithium battery CR2016 (vehicles without a smart key system), or CR2032 (vehicles with a smart key system) Replacing the battery &# ...

Terminals of ecu
1. Inspect tvip ecu Inspect the ecu–b, dome and ecu–ig fuses. disconnect the tvip ecu connector, and the continuity and voltage of check each terminal of the disconnected connector. Standard: If the result is not as specified, the vehicle’s side may malfunction. Reconnect ...

Inspection procedure
Hint: if different dtcs related to different systems that have terminal e2 as the ground terminal are output simultaneously, terminal e2 may be open. Read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malf ...

© 2011-2024 Copyright www.tcorolla.net