1. Dtc check (normal mode)
Notice
: hand–held tester only: when the diagnostic system is switched from the normal mode to the check mode, all the dtcs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the dtcs and freeze frame data, and note them down.
Notice
: when simulating symptoms with an obd ii scan tool (excluding hand–held tester) to check the dtcs, use the normal mode. For codes on the dtcs chart subject to ”2 trip detection logic”, turn the ignition switch off after the symptom is simulated once. Then repeat the simulation process again. When the problem has been simulated twice, the mil is indicated on the instrument panel and dtcs are recorded in the ecm.
2. Dtc clear
Replacement
Hint: components:
1. Remove radiator grille sub–assy
2. Remove front bumper cover
3. Remove lh headlamp assy
Remove the 3 bolts.
pull out the headlight assy lh forward, then disconnect
the bracket of body side.
Release the claws and disconnect the connectors as
show ...
Hood
Adjustment
Hint:
since the centering bolt is used as a hood hinge and hood lock
set bolt, the hood and hood lock can not be adjusted with it on.
Substitute a bolt with washer for the centering bolt.
1. Inspect hood sub–assy
Check that the clearance is within the standard value.
2 ...
Dialing by selecting a name
1 Select “Phonebook” using .
2 Select the desired name using
and press the off-hook switch.
By pressing (Add S. Dial) and then
one of the speed dial buttons (from
to ) while the desired name is selected,
it can be registered as a speed dial. ...