Toyota Corolla (E170) 2014–2019 Owners Manual / Driving / Driving procedures
Toyota Corolla (E170): Driving procedures
- Engine (ignition) switch (vehicles without a smart key system)
- Engine (ignition) switch (vehicles with a smart key system)
- Automatic transmission
- Continuously variable transmission (vehicles without paddle shift switches)
- Continuously variable transmission (vehicles with paddle shift switches)
- Manual transmission
- Turn signal lever
- Parking brake
Other materials:
Overhaul
Hint:
installation is in the reveres order of the removal. But the
installation is indicated only when it has a
point.
In the rh side, work in the same procedure as in the lh side.
1. Remove rear armrest assy lh
Using a screwdriver, remove the rear armrest.
Hint:
tape the s ...
Inspection
1. Inspect defogger relay (marking: def)
Remove the defogger relay from the instrument panel
j/b.
inspect the defogger relay.
Standard:
If the result is not as specified, replace the relay ...
Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center)
Turn the ignition switch to the lock position.
disconnect the aribag sensor assy center connector.
measure the resistance according to the value(s) in the
table below.
Standard:
2 Check wire harness(cg of dl ...