Toyota Corolla (E120): Drive shaft, propeller shaft, axle

Share this page:

Other materials:

Ecm (1zz–fe)
Replacement 1. Disconnect battery negative terminal 2. Remove glove compartment door assy 3. Remove ecm Remove the 2 clips using a clip remover. Then, open the cover. Disconnect the 4 ecm connectors.  remove the wire harness from the wire harness clamp. Remove the 2 ...

Adjustment
1. Inspect and adjust clutch pedal sub–assy Turn over the floor carpet.  check that the pedal height is correct. Pedal height from asphalt sheet: 135.8 – 145.8 Mm (5.346 – 5.740 In.)  adjust the pedal height. Loosen the lock nut and turn the stopper bolt until ...

Circuit description
1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...